Dampness, Leaky Basement Repair, Mildew, or Mold Services in Milwaukee, Wisconsin
A clogged or malfunctioning drain tile system is usually the cause of a damp, wet basement which leads to the growth of mildew or mold. There are two ways in which our company provides the best waterproofing service to repair leaky basement problems for you.
Solution 1
Interior Drain Tile Method
- The waterproofing starts by covering all your valuables with plastic to prevent any possible damage during the repair of your leaky basement walls and floor.
- Remove the concrete floor approximately one foot and remove the old drain tile, if any, for inspection.
- Flush remaining inside drain tile with high-pressure air and water.
- Drill block cores and test hole for proper drainage.
- Drill bleeders to the exterior drain tile and flush clean to allow the system to work.
- Install new drain tile and connect to the existing system at the area of floor removed.
- Cover drain tile with proper filtering stone to allow water to drain properly.
- Re-cement floor at work area.
- Check existing Palmer Valve or sump pump system for proper operation.
- Clean job site in the area are repaired and remove all debris created.
- City permits may be required and will be included upon request.
Licensed, Bonded and Insured! We’ve been in the basement waterproofing and repair business for 70 years and all our work backed by our 20 year warranty! Warranty has no yearly renewal fees and is transferable to new owners.
Solution 2
Exterior Excavation Method is used when basement wall bulging or wall tipped inwards over 1 inch along with the leaky or wet walls
- Major items covered with plastic and carpet runners before we initiate our waterproofing process to repair the leaky basement.
- Cover grass with plywood sheathing to protect repair area.
- Excavate foundation to the footing.
- Haul away clay, set hydraulic jacks, remove loose back-plaster.
- Chip out mortar joints as necessary for straightening.
- Straighten walls back to their original position.
- Rebuild block walls that are severely bulged
Re-waterproof Exterior with 4-Step Process
- Back-plaster cement from footing to grade line.
Seal coat of waterproofing hydro-shield mastic over back-plaster. - Cover back-plaster and seal-coat with vapor barrier plastic.
- Insulation to be installed on walls for expansion control.
- Flush out bleeders and inside drain tile to sump pump or sewer.
- Install new exterior drain tile and connect to texisting system at trench.
- Cover new drain tile with engineered lightweight non-expandable stone to one foot from the top surface per WAFRP standards.
- Cover drain tile and stone back-fill with filter fabric.
- Install custom engineered steel structures at intervals of Approx. 32″ on center.
- Reinforce walls with concrete piers and steel rods in cells of block if needed.
- Re-mortar broken block and mortar joints (tuck-point) inside and outside.
- Compact topsoil with proper pitch at area excavated.
- Reinstall window wells with 100% stone to footing.
- Clean the job site at the repair area and remove all debris as requested.
- City permits may be required and will be included upon request.
Our company has served all king of minor or major waterproofing repairs for leaky basements in Milwaukee, Wisconsin from the last 70 years. Call 414-427-1000 to book an appointment today or write to us at Info@americanwi.com and we will respond as soon as possible.